Geothermal power market has been showing sustainable growth globally, with many installations in developing countries. As people turn to renewable sources while demand for energy is experiencing rapid growth, geothermal is found to be a reliable energy source and current development is calculated to increase global capacity by over 25%. Geothermal power plants can usually be divided into several types of cycles, including binary, flash, double flash and more. Flash power plants are found to be the most common forms of geothermal power plant and specifically, we are going to talk about the double flash cycle.
A flash system produces high pressure dry steam to move the turbine, generating electricity after going through a flash separator. A double flash system uses two flashes separating systems in order to generate more steam from the geothermal liquid and increase cycle output. The cycle starts with high temperature fluid extracted from a geothermal source to a high pressure separator (HPS) for flashing. The HPS produces a saturated steam that enters the high pressure turbine and the remaining brine is directed into a secondary low pressure separator (LPS). Reducing the flashing pressure increases the mixture quality in the LPS, which results in higher steam production. Low pressure saturated steam is mixed with the steam flow exhausted from the high pressure turbine and the resulting steam flow is directed to the low pressure turbine and produces more electricity. Steam that is exhausted from the low pressure turbine will then be compressed and injected back to the ground. In a flash system, separator pressure has a significant effect on the amount of power generated from the system – and the flashing pressures also influence double flash cycle significantly. In order to optimize one design, the value of parameters versus cost of operations should be taken into account.
A double flash system is able to achieve better energy utilization than a single flash cycle, which means that the application has a higher efficiency. At the same geofluid conditions, double flash systems are able to give you a higher capacity. That being said, since this is a more complex system the application of such technology would not be economically feasible for some applications.