Improving Turbine and Compressor Design Matching

Compressor-Turbine-MatchingOne of the most prominent steps of complete gas turbine design is turbine-compressor matching. There are three major components to a gas turbine: compressor, combustor, and turbine. Although all of the components are designed individually, each of the components needs to correspond within the same operating condition range since all are integrated into one cycle. Consequently, an optimal design of each component must fit the requirement of other component’s optimal parameters. Corresponding operating points for each component must be found at equilibrium with the engine, thus the overall performance of gas turbine can be reached within the defined range of parameters.

The idea behind component “matching” process is to find flow and work compatibility between corresponding components. Based on the mechanical constraints, gas generator speed and firing temperature of a gas turbine have limitations depending on: ambient temperature, accessory load and engine geometry. The match temperature chosen should be the ambient temperature which reach both upper limits at the same time.  Pressure ratio needed to allow a certain gas flow is also one of the most prominent parameters that has to be taken into consideration. Designers need to make sure that the gas flow through the power turbine from gas generator satisfy the pressure ratio needed for compressor power requirements. Gas generator can easily show an altered match temperature due to some conditions i.e: reduction in compressor efficiency (due to fouling, etc), change of thermodynamic properties of combustion product, gas fuel with lower or higher hearing value, etc. Match parameters of an engine could also be altered by changing the flow characteristics on the first turbine nozzle.Turbine-Compressor

Using characteristic map/curve as well as thermodynamic relationships of turbine and compressor, calculations can be performed to identify the permitted operating range. It must be taken into consideration that all calculated value must match the value from map data.

Trying to find the fastest solution for this step? SoftInWay’s turbine-compressor matching feature in AxSTREAM could help you cut engineering time and simplify the process. Combining performance maps of turbine and compressor, making it easier for the user to determine points of joints operations.

Take a look into AxSTREAM’s to learn more about this.

Turbine Compressor Matching Compatibility Mode Document

One thought on “Improving Turbine and Compressor Design Matching

  1. Hello sir, I am interested to know how turbine & compressor power matching is done analytically, could you please guide me.

Leave a Reply

Your email address will not be published. Required fields are marked *